Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Vacuum brake control valve oil??


 
Post new topic    
View previous topic :: View next topic  
Author Message
Cariboo4x4
Long Time User


Joined: 23 Nov 2014
Posts: 609


Report to Moderator

PostPosted: Thu Dec 17, 2020 7:27 am    Post subject: Vacuum brake control valve oil?? Reply to specific post Reply with quote

I just put this new brake booster-slave cylinder in this 1977 International Loadstar 1700 and instructions say to put lubricant in control valve. Here is a photo of instructions and the booster I put in is shown on top right of instructions. Part supplier is phoning manufacturer this morning yet he may get side tracked. A fellows online suggested neats foot oil or air tool oil. Any suggestions? Wouldnt it have modern components such as rubber vs leather and come pre lubricanted?

 
Back to top
View user's profile
TGP
Long Time User


Joined: 05 Mar 2009
Posts: 638


Report to Moderator

PostPosted: Sat Dec 19, 2020 2:48 pm    Post subject: Re: Vacuum brake control valve oil?? Reply to specific post Reply with quote

If I was going to use anything it would be Air Tool Oil.
Very gentle on rubber components compared to other oils.

I know that's what we use on the Air-Pack on Air over Hyd. brakes.

Tom
 
Back to top
View user's profile
Cariboo4x4
Long Time User


Joined: 23 Nov 2014
Posts: 609


Report to Moderator

PostPosted: Sun Dec 20, 2020 10:11 am    Post subject: Re: Vacuum brake control valve oil?? Reply to specific post Reply with quote

TGP wrote:
(quoted from post at 15:48:56 12/19/20) If I was going to use anything it would be Air Tool Oil.
Very gentle on rubber components compared to other oils.

I know that's what we use on the Air-Pack on Air over Hyd. brakes.

Tom



Thank you Tom. I finally talked to manufacturer tech on phone and he said the unit is pre lubed. From my research older vehicles had leather seals that needed periodic lubricant.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Yesterday's Trucks All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters