Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

wd,missing pilot bearing


 
Post new topic    
View previous topic :: View next topic  
Author Message
joe brabank
New User


Joined: 23 Apr 2020
Posts: 9


Report to Moderator

PostPosted: Wed Jan 13, 2021 9:44 am    Post subject: wd,missing pilot bearing Reply to specific post Reply with quote

tractor s/n wd111726,engine s/n wd320877pa. during tear down found the pilot bearing missing.after searching threw the wd/wd45 service manual under flywheel "the pilot bearing was removed w engine s/n 310920 and the shaft changed.no pilot bearing is needed."effective with wd45 engine s/n30956 the pilot bearing is again being used.the other 4 wds i tore down to make one good tractor all had pilot bearings.can i and should i install a pilot bearing when reassembling this tractor? also plan on ordering an engine kit from YT,has anyone used these kits?
 
Back to top
View user's profile
DrAllis
Tractor Expert


Joined: 18 Jan 2015
Posts: 1540


Report to Moderator

PostPosted: Wed Jan 13, 2021 10:29 am    Post subject: Re: wd,missing pilot bearing Reply to specific post Reply with quote

I was in diapers when this happened. I was told it was a bad idea and that they had to go back to the old way. Now, I have seen some tractors that had a thin tin shim wrapped around the clutch shaft nose to bring the clutch shaft nose O.D. back up to fit the pilot brg I.D., so be sure to check that out.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Allis Chalmers All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters