Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

KEC rod and main torque


 
Post new topic    
View previous topic :: View next topic  
Author Message
iowa806
Regular


Joined: 04 Mar 2018
Posts: 21


Report to Moderator

PostPosted: Wed Apr 07, 2021 11:04 am    Post subject: KEC rod and main torque Reply to specific post Reply with quote

Can anyone tell me the torque for rods and mains on a 39 uts. It has the KEC block with babbitt bearings. I have the I&T manual but they are not in there.
 
Back to top
View user's profile
molinegb
Tractor Expert


Joined: 13 Feb 2005
Posts: 2947


Report to Moderator

PostPosted: Wed Apr 07, 2021 4:35 pm    Post subject: Re: KEC rod and main torque Reply to specific post Reply with quote

There is no torque specs on babbit KEA or KEC,KED. Just remove or add shims till not tight and pin them. Go by bolt size for rough. 65-70. Not high rpm's.
 
Back to top
View user's profile
iowa806
Regular


Joined: 04 Mar 2018
Posts: 21


Report to Moderator

PostPosted: Wed Apr 07, 2021 5:02 pm    Post subject: Re: KEC rod and main torque Reply to specific post Reply with quote

Ok I had a feeling that was the way it was done but wanted to make sure. Thank you for the information
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Minneapolis Moline All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters