Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

John deere l


 
Post new topic    
View previous topic :: View next topic  
Author Message
jd man wis
Long Time User


Joined: 27 Apr 2014
Posts: 759


Report to Moderator

PostPosted: Thu Apr 08, 2021 4:31 am    Post subject: John deere l Reply to specific post Reply with quote

I was wondering if there was a spray
like that I can put on the cultivator so
the paint would stick to it. I guess I'm
being lazy some instead of sanding it or
sand plating the cultivator. I would like
to spray it but also looks like a
challenge to do. Might have to brush it.
Thanks guys.
 
Back to top
View user's profile
Stephen Newell
Tractor Guru


Joined: 11 Jun 2011
Posts: 9759


Report to Moderator

PostPosted: Thu Apr 08, 2021 1:46 pm    Post subject: Re: John deere l Reply to specific post Reply with quote

It's not so much that paint won't stick, it's just difficult to get a paint that is hard enough that won't rub off. Soil is very abrasive. Your best bet would be powder coat but that's not really a diy coating. Sherwin Williams makes a paint called Sher-Kem enamel that would hold up better than the average paint. It don't come in rattle can though.
 
Back to top
View user's profile
showcrop
Tractor Guru


Joined: 13 Dec 2000
Posts: 30307
Location: Chester NH

Report to Moderator

PostPosted: Thu Apr 08, 2021 4:29 pm    Post subject: Re: John deere l Reply to specific post Reply with quote



Yes there is. It is called primer paint. Don't even dream of using powder coat unless you are sure that whatever it is will never get scratched. powder coat is like putting rust on steroids.
 
Back to top
View user's profile
jd man wis
Long Time User


Joined: 27 Apr 2014
Posts: 759


Report to Moderator

PostPosted: Fri Apr 09, 2021 12:47 am    Post subject: Re: John deere l Reply to specific post Reply with quote

Thanks for the info guys on the cultivator. I don't plan on using it in the ground just going to be at shows. Also iv seen the shovels on a 37B that where red?. Do you guys know if the 37l is sopose to be like that or just green. I ask the guy about it an he said it was done that way so you could see it to cultavat the corn. I said really what do you do after the frist cupull passes and the paint is gone. The one on the 45B was silver from the ground.
 
Back to top
View user's profile
Mark-Ia
Tractor Guru


Joined: 29 Jan 2011
Posts: 5283


Report to Moderator

PostPosted: Sat Apr 10, 2021 7:09 am    Post subject: Re: John deere l Reply to specific post Reply with quote

Shovel weren't red, but the shank that the shovel mounted to were red on the early models.
 
Back to top
View user's profile
jd man wis
Long Time User


Joined: 27 Apr 2014
Posts: 759


Report to Moderator

PostPosted: Sat Apr 10, 2021 4:52 pm    Post subject: Re: John deere l Reply to specific post Reply with quote

Thanks that what I'll do then.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Paint and Bodywork All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters