Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

960 starter


 
Post new topic    
View previous topic :: View next topic  
Author Message
pinball
Tractor Expert


Joined: 13 Jun 2007
Posts: 2063


Report to Moderator

PostPosted: Sat May 15, 2021 3:59 am    Post subject: 960 starter Reply to specific post Reply with quote

my starter went out. got a new one. how do i remove the bendix from the old starter. thanks
 
Back to top
View user's profile
Sean in PA
Tractor Guru


Joined: 27 Feb 2008
Posts: 9144
Location: Southeast PA

Report to Moderator

PostPosted: Sat May 15, 2021 5:12 am    Post subject: Re: 960 starter Reply to specific post Reply with quote

If you're talking about the drive on the end of the shaft with the gear that moves to engage the ring gear, that is held in place by a roll pin.
 
Back to top
View user's profile
pinball
Tractor Expert


Joined: 13 Jun 2007
Posts: 2063


Report to Moderator

PostPosted: Sun May 16, 2021 2:22 am    Post subject: Re: 960 starter Reply to specific post Reply with quote

thanks
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Ford All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters