Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

wd 45 D

Post new topic    
View previous topic :: View next topic  
Author Message

Joined: 16 May 2010
Posts: 98

Report to Moderator

PostPosted: Sun Mar 17, 2013 6:40 am    Post subject: wd 45 D Reply to specific post Reply with quote

Need help 230 buda, timing marks on cam will not match crank gear or pump gear. If you line up crank and cam marks, the cam and pump gear are 4 teeth off. What do you do ?
Back to top
View user's profile
Tractor Guru

Joined: 29 Feb 2012
Posts: 6459
Location: Indiana

Report to Moderator

PostPosted: Sun Mar 17, 2013 7:43 am    Post subject: Re: wd 45 D Reply to specific post Reply with quote

Pump gear mark is not needed, just make sure cam/crank marks are right. Then with #1&6 at TDC, valves rocking on #6 you know #1 is ready to fire. Then back crank up past pump timing mark and roll forward to the mark. Install pump gear while turning hub to line up pointer mark. Make sure pump is on cyl #1 by finding head gear mark, if you see it in the window you are on 1. If not pump is on #6 and needs turned 1 revolution. This pump turns engine speed while hydraulic head turns 1/2 same as the cam.
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Allis Chalmers All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters