Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Case 730/741 Tune up specs

Post new topic    
View previous topic :: View next topic  
Author Message
Robert Helmer
New User

Joined: 25 Jun 2013
Posts: 6

Report to Moderator

PostPosted: Thu Jun 27, 2013 6:29 am    Post subject: Case 730/741 Tune up specs Reply to specific post Reply with quote

Trying to help a female cousin that has Grampa's old tractor. Can anyone tell me what the point gap and/or dwell should be on a Case 730/741? Also-on same tractor, where do I start with diagnosing a PTO that they say is "slipping". Has new fluid and filter, and is full. Is it possible that they put in "generic" fluid rather than a specific type or will plain hydraulic fluid work? They didn't have a quick answer for me.
Back to top
View user's profile

Joined: 21 Mar 2012
Posts: 149

Report to Moderator

PostPosted: Thu Jun 27, 2013 7:14 am    Post subject: Re: Case 730/741 Tune up specs Reply to specific post Reply with quote

.020 gap. The pto probably needs adjusted. The engagemt lever shoule apply with something like 50 lbs force and snap over to engage. If its not lije that it needs tightened up. Somebody posted a repair manual pic a few days back explaining the procedure
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Case and David Brown All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters