Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Touch Control Lever Stop Cam ????????


 
Post new topic    
View previous topic :: View next topic  
Author Message
RICK IN GA
Regular


Joined: 18 Jan 2012
Posts: 143


Report to Moderator

PostPosted: Mon Feb 16, 2015 1:10 pm    Post subject: Touch Control Lever Stop Cam ???????? Reply to specific post Reply with quote

Spent a lot of time going through the archives on this hydraulic adjustment procedure. Have not done it yet but need to now before I put my hydraulics back in the 881-D. I have read the Alternate procedure in the manuals and it says to "move the touch control lever against the cam stop in the raised position." In looking at my parts manuals it shows that the cam stop (930) only goes from 53/56. So I checked my 3 available 01 Series and none of them have the cam. My 54 NAA does have the cam. So here's the question.....How far do I move the touch control lever?????


 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Ford All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters