Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

403 eng in a ubspecial

Post new topic    
View previous topic :: View next topic  
Author Message
Dick Battershell
New User

Joined: 26 Apr 2012
Posts: 4

Report to Moderator

PostPosted: Mon Jan 01, 2018 8:09 am    Post subject: 403 eng in a ubspecial Reply to specific post Reply with quote

is it possible to install a 403 eng in a ubspecial? thank-you
Back to top
View user's profile

Joined: 24 Jun 2008
Posts: 45

Report to Moderator

PostPosted: Mon Jan 01, 2018 2:10 pm    Post subject: Re: 403 eng in a ubspecial Reply to specific post Reply with quote

You can do it 2 ways.
Put the crank and blocks and rods in the 283 crankcase, Or put the whole engine in in place of the 283.
If you put the 403 crankcase in you will have to grind out for starter to fit in. That is what I did.

Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Minneapolis Moline All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters