Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

TEA-20 3-point lower lift arm support pin.


 
Post new topic    
View previous topic :: View next topic  
Author Message
Hodgy
Regular


Joined: 17 Nov 2010
Posts: 51


Report to Moderator

PostPosted: Sat Feb 10, 2018 2:46 pm    Post subject: TEA-20 3-point lower lift arm support pin. Reply to specific post Reply with quote

I have a TEA-20. Is there a cotter pin through the nut on the inside of the rear end ?

I want to remove the 3-point lower lift arm support pin.


I don't really want to remove the "trumpet" if I can help it.

Some of the posts say you can get at the right one but not the left one. I can't reply to the OP as they are to old.



Thanks
 
Back to top
View user's profile
Royse
Tractor Guru


Joined: 17 Jan 2011
Posts: 17439
Location: Ionia County Michigan

Report to Moderator

PostPosted: Sat Feb 10, 2018 3:05 pm    Post subject: Re: TEA-20 3-point lower lift arm support pin. Reply to specific post Reply with quote

I've never taken the rear apart on my TE-20, but on the Fords
they have a castellated nut with a cotter key through it.
On those you can take the left axle trumpet off, remove the
differential and get to both sides through the left side.

If it's leaking, I'd try to get to it sooner rather than later.
It will wallow out the hole if left loose and won't be able to seal.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Tractor Talk All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters