Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

3000 3 point hitch

Post new topic    
View previous topic :: View next topic  
Author Message

Joined: 20 Jan 2014
Posts: 27

Report to Moderator

PostPosted: Thu Jun 14, 2018 4:08 am    Post subject: 3000 3 point hitch Reply to specific post Reply with quote

I just had to remove the rockshaft housing for bearing replacement. When I re-installed the housing I made sure the lift arms were down and
the positioning lever was in the down position. However when I got the tractor started the lift arms would not raise - any thoughts? Thanks
in advance.
Back to top
View user's profile
Tractor Guru

Joined: 22 Nov 2011
Posts: 9282

Report to Moderator

PostPosted: Thu Jun 14, 2018 4:50 am    Post subject: Re: 3000 3 point hitch Reply to specific post Reply with quote

May need to prime the system. Up-down-up down on the position control till it primes itself if all you need to do is get rid of trapped air.
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Ford All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters