Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

welder farmall stationary engine


 
Post new topic    
View previous topic :: View next topic  
Author Message
montanaelkhunter
New User


Joined: 20 Apr 2003
Posts: 11


Report to Moderator

PostPosted: Thu Sep 20, 2018 10:37 am    Post subject: welder farmall stationary engine Reply to specific post Reply with quote

I have an old welder powered by an older farmall engine. I rescued it from a barn several years ago and am getting it going again. There are just casting numbers and no serial number that I can find on the engine. The oil filter number was destroyed by the oil years ago but an 85172 fits the canister. I am thinking it is an "A" engine but what is the best way to be sure? Any help would be appreciated.
 
Back to top
View user's profile
leroy in ne
Long Time User


Joined: 02 Sep 2014
Posts: 1194


Report to Moderator

PostPosted: Thu Sep 20, 2018 11:18 am    Post subject: Re: welder farmall stationary engine Reply to specific post Reply with quote

I believe if this is an A engine the serial # should be on the right side if the block around 1 inch below the head and 2 or 3 inches back from the front corner on a machined pad.
 
Back to top
View user's profile
montanaelkhunter
New User


Joined: 20 Apr 2003
Posts: 11


Report to Moderator

PostPosted: Thu Sep 20, 2018 3:03 pm    Post subject: Re: welder farmall stationary engine Reply to specific post Reply with quote

Thanks very much. I had thought so too, but had not seen the machined flat spot behind the throttle linkage. I should have known better. Now I just need to research the serial number. Thanks again.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Farmall & International Harvester (IHC) All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters