Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Rim/tire mounting combination


 
Post new topic    
View previous topic :: View next topic  
Author Message
Epjisme
New User


Joined: 15 Jun 2019
Posts: 3


Report to Moderator

PostPosted: Sat Jun 29, 2019 4:23 am    Post subject: Rim/tire mounting combination Reply to specific post Reply with quote

I recently bought an IH 606 with loaded power adjust rims. Needless to say the calcium ruined the rims. I found a set of discs and rims to replace them with but not sure of the best way to mount them,dished in or out and then what position to mount the 6 loop wheels to the disc. I know there are a lot of different options just wondering what your thoughts are on it. Thanks.
 
Back to top
View user's profile
Jim.ME
Long Time User


Joined: 02 Mar 2018
Posts: 911


Report to Moderator

PostPosted: Sat Jun 29, 2019 2:08 pm    Post subject: Re: Rim/tire mounting combination Reply to specific post Reply with quote

You really have to decide that for yourself and your circumstances. Do you have width restrictions where you store or run it, so you might want it narrow? Are you doing any crop work where the spacing needs to match rows? Is it a wide front, where you want the rears to track the fronts? Are you going to run on side hills? How wide are the spin outs set? Is that width good for you? By turning the discs dish in or out, turning the rims, and using both sides of the loops you have may choices.

I'd set them mid-way if there were no other governing factors and with a wide front, center its width to the rears. JMO, Others may have different thoughts.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Restoration and Repair Tips All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters