Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

3pt log splitter


 
Post new topic    
View previous topic :: View next topic  
Author Message
steve19438
Tractor Guru


Joined: 30 May 2011
Posts: 4262
Location: harleysville pa

Report to Moderator

PostPosted: Tue Jan 08, 2019 5:47 am    Post subject: 3pt log splitter Reply to specific post Reply with quote

is this something my MF 50 could handle ? (not too slow ?)
Untitled URL Link

 
Back to top
View user's profile
miner09
Tractor Expert


Joined: 02 Dec 2009
Posts: 2693


Report to Moderator

PostPosted: Tue Jan 08, 2019 6:42 am    Post subject: Re: 3pt log splitter Reply to specific post Reply with quote

Should work good. Not sure what GPM your pump is.
 
Back to top
View user's profile
Tom Massachusetts
Regular


Joined: 22 Jan 2014
Posts: 63


Report to Moderator

PostPosted: Tue Jan 08, 2019 6:53 am    Post subject: Re: 3pt log splitter Reply to specific post Reply with quote

I have a similar splitter on my MH50 and had to use a PTO pump. The tractor hydraulics were too slow.
 
Back to top
View user's profile
John Deere D
Tractor Expert


Joined: 14 Jun 2011
Posts: 3305


Report to Moderator

PostPosted: Tue Jan 08, 2019 7:09 am    Post subject: Re: 3pt log splitter Reply to specific post Reply with quote

I have a similar home built splinter......MF FE 35 X....

At 2200 PSI hydraulic supply pressure..

(1) I had to Increased Cylinder to 5" diam...
(2) GPM of MF FE 35 X pump was quite low..
(3) 16" knotty dry pine required the 5" diam Cylinder....
(4) Attached splinter to my Case 830....GPM of Case is such that Cylinder operates at perfect speed..

Bob.....
 
Back to top
View user's profile
ptfarmer
Tractor Guru


Joined: 01 Jul 2013
Posts: 5692


Report to Moderator

PostPosted: Wed Jan 09, 2019 7:18 am    Post subject: Re: 3pt log splitter Reply to specific post Reply with quote

The hydraulic pump on the 50 is around 4.5 gallons per minute (gpm), the pump on the 830 Case is supposedly around 15 gpm.
 
Back to top
View user's profile
steve19438
Tractor Guru


Joined: 30 May 2011
Posts: 4262
Location: harleysville pa

Report to Moderator

PostPosted: Wed Jan 09, 2019 2:02 pm    Post subject: Re: 3pt log splitter Reply to specific post Reply with quote

thanks fellas. I guess I will pass.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Massey Harris & Massey Ferguson All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters