Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Case tractor -identification


 
Post new topic    
View previous topic :: View next topic  
Author Message
richard White
Guest






Report to Moderator

PostPosted: Wed May 23, 2007 9:34 am    Post subject: Case tractor -identification Reply to specific post Reply with quote

Greetings ! Iam trying to identify my Case crop row tractor. There is two tiny holes in the instrement panel where the ID plate used to be .
There are various part numbers - but they all start with VT , it has a overhead valve 4cyl. motor. The previous owner says he thought it was made in the 1940's. It's hard to order parts, so could you help me ? thanks !

 
Back to top
Gene Dotson
Guest






Report to Moderator

PostPosted: Wed May 23, 2007 10:20 am    Post subject: Re: Case tractor -identification Reply to specific post Reply with quote

Richard;

This will be a VA series tractor. If it has 28 inch or 32 inch rear tires it is a VAC. Can be a narrow front. With 24 inch rear tires and wide non adjustable front it will likely be a VA or VAI tractor..... Gene


 

Back to top
Joe (Wa)
Guest






Report to Moderator

PostPosted: Wed May 23, 2007 11:52 am    Post subject: Re: Case tractor -identification Reply to specific post Reply with quote

The VT casting nrs make it VA series. To ID the model in the series, you will need to post more info or check in "Tractor Photos" under GALLERIES on the left side of this page.

Engine serial nrs are in chronological sequence, with some overlap, and can be used to approximate a range of build years assuming the engine is original.

The engine serial nr is stamped into the block above the starter, early tractors stamped hornizontal just under the cylinder head gasket, later tractors stamped vertical on the milled pad just above the starter.

Joe



 

Back to top
:   
Post new topic    Yesterday's Tractors Forum Index -> Case and David Brown All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters