Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

3309 case international mower

Post new topic    
View previous topic :: View next topic  
Author Message

Joined: 02 Feb 2019
Posts: 21

Report to Moderator

PostPosted: Fri Jul 19, 2019 11:26 am    Post subject: 3309 case international mower Reply to specific post Reply with quote

SO I am having to work on the cutterbar. The 2nd turtle shell in had a break on the housing that the top gear screws into. There are 4 allen bolts that go into that house to secure to the lower housing that has the lower gear. I guess one of these bolts came loose and the other 3 were pulled out and the lower casing broke the part the screws go into.

I have purchased the new casing.....and I know you have to start on the end of the unit and take each casing off in order to get to the one that is broke to repair.

My difficulty......I have removed the front and back hex pipe the only think is the casing spring around the pipe but it will not pull off. I have removed the lock key on the lower pully side....but have no room to get to the other side to see if there are lock keys there.

I have been told there is a long shaft that goes the length of the cutterbar?..and the shaft that I see inside of the casing with the lower gear will slide off over the full shaft..but I am having no luck...course I am in the field and have about half of my field down and trying to figure this out.
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Implement Alley All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters