Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Ford 2110 clutch alignment tool


 
Post new topic    
View previous topic :: View next topic  
Author Message
mtestagolf
New User


Joined: 02 Oct 2019
Posts: 1


Report to Moderator

PostPosted: Wed Oct 02, 2019 11:23 am    Post subject: Ford 2110 clutch alignment tool Reply to specific post Reply with quote

I have a ford 2110(mid 80's), 4 cylinder diesel. It has the 2 disc clutch and has the shibura engine in it. I finally found the right clutch for it, but cant find the right alignment tool. It has the 9.5 dual disc, one disc is 15/16 with 13 spline, and other disc is 1 3/8 19 spline. The pilot bearing inside is .4724-.475. I can find clutch alignment tools for the right spline count and size, but cant find the right pilot size, the smallest pilot size is .669. Any help would be great, thanks Mark
 
Back to top
View user's profile
showcrop
Tractor Guru


Joined: 13 Dec 2000
Posts: 27652
Location: Chester NH

Report to Moderator

PostPosted: Thu Oct 03, 2019 3:42 pm    Post subject: Re: Ford 2110 clutch alignment tool Reply to specific post Reply with quote


I have done various clutches including combined clutches and a double disc with a floater without an alignment tool. I put it on with it close and tighten the bolts to not quite snug, then just stick a broom handle or piece of tubing in to get it close, just edging the discs with a screwdriver. Then tighten to spec. When slipping the back end back to the front turn the PTO shaft to get it to mesh.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Ford All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters