Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

220 fwa


 
Post new topic    
View previous topic :: View next topic  
Author Message
2 9600
Regular


Joined: 25 Jan 2016
Posts: 274


Report to Moderator

PostPosted: Fri Dec 20, 2019 12:36 pm    Post subject: 220 fwa Reply to specific post Reply with quote

I recently viewed a post I can not find , about the two twenty fwas , that 100 were made , and 50 recalled , and coverted to 2wd . by removing the fwa , and covering the trans slash rearend with a cover . my question , where did the fwa / plate get bolted to trans , rearend . and does any one have a picture of it
 
Back to top
View user's profile
DrAllis
Tractor Expert


Joined: 18 Jan 2015
Posts: 1601


Report to Moderator

PostPosted: Fri Dec 20, 2019 7:55 pm    Post subject: Re: 220 fwa Reply to specific post Reply with quote

Doubt very much that there were 50 reconfigured to a 2WD. Maybe 20. The cover plate would be on the bottom of the rear end housing at the front of the housing where it mates with the 4-speed transmission. Another clue would be 4th gear is 5.8 MPH (instead of 4.5 MPH) and 5th gear is 6.3 MPH which is very close to 4th. The FWA only worked in the lower 4 gear selections.
 
Back to top
View user's profile
2 9600
Regular


Joined: 25 Jan 2016
Posts: 274


Report to Moderator

PostPosted: Thu Dec 26, 2019 8:53 am    Post subject: Re: 220 fwa Reply to specific post Reply with quote

not arguing dr allis just what I had read one time , so how many do you think were sent back
 
Back to top
View user's profile
DrAllis
Tractor Expert


Joined: 18 Jan 2015
Posts: 1601


Report to Moderator

PostPosted: Thu Dec 26, 2019 12:54 pm    Post subject: Re: 220 fwa Reply to specific post Reply with quote

Not 50. That would have been half of the 100 they originally built. Personally, I think 10 or less, but I have no way to prove it.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Allis Chalmers All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters