Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

1969 c850.


 
Post new topic    
View previous topic :: View next topic  
Author Message
Schneider
Regular


Joined: 01 Jan 2017
Posts: 81
Location: Michigan

Report to Moderator

PostPosted: Fri Oct 30, 2020 2:38 pm    Post subject: 1969 c850. Reply to specific post Reply with quote

A friend just gave me his 1969 C 850. It was an old fire truck
that he put a flat bed on. 13,000 original miles. I think it is a
534 gas engine.

Ran well for him until he noticed a gas leak at the carb. He
had the carb rebuilt. Drove it home and it burst into flame on
top of the engine. Took 5 extinguishers to put it out. Mechanic
said to bring the carb in and if it was something they did wrong
they would rebuild it again.

That was 3 years ago. I just took the carb off. Holley.

Any idea what the original carb would have been? This carb is
setup like nothing i have seen before. The riser it was set on
had its own butterfly’s and a linkage set up to a thermostatic
control. And another linkage running back to a contraption on
the manifold. Ill post a picture.

He said it ran great before the fire
 
Back to top
View user's profile
Longknife
Regular


Joined: 22 Jan 2010
Posts: 212


Report to Moderator

PostPosted: Mon Nov 02, 2020 8:03 am    Post subject: Re: 1969 c850. Reply to specific post Reply with quote

[quote="Schneider"](reply to post at 23:38:35 10/30/20) [/quo

534 engine? Maybe the LV 549? The "riser is probably a goverenor!

https://en.wikipedia.org/wiki/List_of_International_Harvester/Navistar_engines
 
Back to top
View user's profile
DoubleO7
Tractor Guru


Joined: 27 Oct 2017
Posts: 6338


Report to Moderator

PostPosted: Wed Nov 04, 2020 12:44 pm    Post subject: Re: 1969 c850. Reply to specific post Reply with quote


Original is a Ford spec Holley #9-4263

An Edelbrock AVS2 can be a good substitute.

I believe the original carb has a governor built into it however.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Yesterday's Trucks All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters