Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Questions About Mounting 291B Loader.


 
Post new topic    
View previous topic :: View next topic  
Author Message
L.Fure
Tractor Expert


Joined: 17 Jun 2013
Posts: 2979


Report to Moderator

PostPosted: Tue Jul 14, 2020 4:26 pm    Post subject: Questions About Mounting 291B Loader. Reply to specific post Reply with quote

Here's the deal. I have a model 291B loader that is mounted on an early 530. I want to mount the loader on my 611B. I have the operators instruction manual, but it leaves out a lot of details. One question I have is whether or not I remove the side rails, the piece of steel that is bolted to the bell housing on one end and the front bolster on the other end, or leave them on? The 530 doesn't have these rails. When I remove the loader from the 530 do I need to find a set of these rails to put on the tractor, or is this something I can live without?
The 611B has power steering that uses a power steering motor in the steering linkage. The mounting bracket is bolted to the side rail. If I do have to remove the side rails where do I mount the power steering motor? The sub frame of the loader has a large square hole where the steering motor should bolt on.

Well, that's what I have for now. I'm sure more questions will pop up later.
 
Back to top
View user's profile
L.Fure
Tractor Expert


Joined: 17 Jun 2013
Posts: 2979


Report to Moderator

PostPosted: Sun Jul 19, 2020 5:09 pm    Post subject: Re: Questions About Mounting 291B Loader. Reply to specific post Reply with quote


The reason I ask these questions is that the sub frames are heavy and I don't want to lift them any more than I have to.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Case and David Brown All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters