Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

farmall 300 motor estimated cost


 
Post new topic    
View previous topic :: View next topic  
Author Message
pulls red
Guest






Report to Moderator

PostPosted: Mon Jun 11, 2007 9:00 am    Post subject: farmall 300 motor estimated cost Reply to specific post Reply with quote

How much would it cost to have a 300 block machined to accept a 6 inch crank and a 4.375 bore. And how about cost for sleevs and pistons I have everything else.

 
Back to top
ChadS
Guest






Report to Moderator

PostPosted: Tue Jun 12, 2007 5:59 am    Post subject: Re: farmall 300 motor estimated cost Reply to specific post Reply with quote

I got a 300 block aready bored out with big sleeves ready for finish work. right at 4 inch bore with a thick sleeve. Hard block it, grind it out and its ready. Chad

 
Back to top
AC
Guest






Report to Moderator

PostPosted: Tue Jun 12, 2007 6:47 pm    Post subject: Re: farmall 300 motor estimated cost Reply to specific post Reply with quote

So, you DO already have a 6.00" crank, then?

 
Back to top
Anonymous
Guest






Report to Moderator

PostPosted: Wed Jun 13, 2007 8:21 am    Post subject: Re: farmall 300 motor estimated cost Reply to specific post Reply with quote

Yes I have every thing but sleeves and pistons. I was wondering how much it cost to see if its worth it.
 
Back to top
:   
Post new topic    Yesterday's Tractors Forum Index -> Tractor Pulling All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters