Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Work cylinder rod pin, is there play? MF-85


 
Post new topic    
View previous topic :: View next topic  
Author Message
Tophers_Farm
New User


Joined: 15 Feb 2018
Posts: 5


Report to Moderator

PostPosted: Sun Sep 27, 2020 8:03 am    Post subject: Work cylinder rod pin, is there play? MF-85 Reply to specific post Reply with quote

Is the pin for the work cylinder rod to the ram arm supposed to have some play with the hole in the rod?

I have not been able to find this exact part so I will to have to make one, there are 2 pins in the parts manual, but it is difficult to tell which one is which.
It looks as though I am looking for 3/8" diameter by 5" and I assuming that the rod should push on the ram arm before contacting the pin (the pin is just there to keep it from falling).


I have a MF-85 very similar to MF-65. I thought the hydraulic pump valves were clogged because the 3 point hitch arms were stuck in the air. When I took the lift cover off the work cylinder rod fell right out.

There was no pin holding the rod to the ram arm so it looks more likely to be the reason the the 3 point was stuck.
 
Back to top
View user's profile
Bruce(OR)
Tractor Guru


Joined: 10 Apr 2007
Posts: 3535


Report to Moderator

PostPosted: Sun Sep 27, 2020 9:33 pm    Post subject: Re: Work cylinder rod pin, is there play? MF-85 Reply to specific post Reply with quote

Ya' might try the Whiz-Bang modern Massey Fergy Board.
This is when a Fergy was a Fergy tractor board.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Harry Ferguson All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters