Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

john deere 2020 knee bushing removal

Post new topic    
View previous topic :: View next topic  
Author Message
New User

Joined: 09 Nov 2020
Posts: 11

Report to Moderator

PostPosted: Sun Jan 10, 2021 3:01 pm    Post subject: john deere 2020 knee bushing removal Reply to specific post Reply with quote

Start with replacing the hubs...worn bolt holes. Once I relieved the weight off of the wheels, I noticed that the knee bushings are worn. In particular the top bushings. After removing the tie rod end, I also see that the bell crank bearing is shot too. I am glad that I have plenty of time before spring.... any suggestions as to the best Way to remove the worn knee bushings? I spent a little bit of time trying to drive them out. No movement at all. Try cutting the bushing? Any suggestions?
Back to top
View user's profile
Tx Jim
Tractor Guru

Joined: 14 Feb 1999
Posts: 29978

Report to Moderator

PostPosted: Mon Jan 11, 2021 2:34 am    Post subject: Re: john deere 2020 knee bushing removal Reply to specific post Reply with quote

Drive bushings out with a long bar & BIG HAMMER or utilize an acetylene torch to split old bushings.
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> John Deere All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters