Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Dexta: How do I remove the position control follower pin


 
Post new topic    
View previous topic :: View next topic  
Author Message
FarmallM51
Regular


Joined: 25 Sep 2008
Posts: 27


Report to Moderator

PostPosted: Thu Jan 14, 2021 1:48 pm    Post subject: Dexta: How do I remove the position control follow Reply to specific post Reply with quote

I have the 3-point lift casting removed from the top of the rear end on my 1960 Dexta and the position control follower pin (I hope that's the correct term) is worn nearly through. How do I remove it from the cast lever that it seems to be pressed in to? Can I tap it out with a hammer & punch? Do I need to remove the cast lever & press the pin out? I also need the USA part number. Thanks.
Marlin
 
Back to top
View user's profile
FarmallM51
Regular


Joined: 25 Sep 2008
Posts: 27


Report to Moderator

PostPosted: Fri Jan 15, 2021 2:04 pm    Post subject: Re: Dexta: How do I remove the position control fo Reply to specific post Reply with quote

I have removed the position control arm. I failed to press it out with a 6" bench vice. Should I try heat first, or move to a 20 ton press. I don't want to break the arm. Thanks.
Marlin
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Fordson All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters