Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Re: Bans


 
Post new topic    
View previous topic :: View next topic  
Author Message
Rich'sToys
Tractor Expert


Joined: 09 Feb 2011
Posts: 3335
Location: MN

Report to Moderator

PostPosted: Fri Apr 09, 2021 8:40 pm    Post subject: Re: Bans Reply to specific post Reply with quote

Thanks for your post on the topic. Your points are well taken, and I couldn't agree more.

One comment I would have--It's unfortunate that an entire thread has to get poofed because one or two individuals decided to take it off the rails. Much good information has been lost at times due to this.
These forums are too large for one person to moderate by his or her self, especially if that person has other duties as well. Other forums I'm on have multiple moderators who can monitor things more closely and delete only the offensive comments and leave the rest. They can also move threads which are posted in the wrong forums or are off topic. They could also edit out the bad stuff if we had that capability here.
It's a little easier to enforce the rules if more than one person is doing it.
Just something to think about.
 
Back to top
View user's profile
YTSupport
Site Admin


Joined: 01 Jan 1997
Posts: 8350


Report to Moderator

PostPosted: Fri Apr 09, 2021 9:13 pm    Post subject: Re: Bans Reply to specific post Reply with quote

That has always been a good idea, but classic view doesn't allow it. It is a very complex set of files to manipulate. Kim writes programs to deal with it but making them available to others, means another layer of user programs to write, debug, correct when they break, develop permissions that enable others to use them etc.

That's also the reason that sifting through to save a thread is almost never worth the time it takes to do it.

Good ideas though definitely. The choice to keep classic view for people was far reaching.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Site Comments All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters