Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Case 930 hard starting


 
Post new topic    
View previous topic :: View next topic  
Author Message
NFD17
Regular


Joined: 28 Apr 2021
Posts: 39


Report to Moderator

PostPosted: Wed May 05, 2021 4:17 am    Post subject: Case 930 hard starting Reply to specific post Reply with quote

My Case 930 used to bust off in a rev or two, then about a year ago a
neighbors dope head grown son went in the shed and got the tractor
without permission. He used the tractor to pull his truck out of another
persons field where he got stuck while stealing parts off of one of that
mans trucks. He wrapped a chain in such a way that he jerked the lower
radiator hose off and wound up running the tractor hot, how hot I dont
really know but the gauge was not pegged out and stuck so I hoped
maybe not that bad or not too long. Since that all took place the tractor
has been extremely hard starting and black smokes when it finally does
start, I have run it long enough to make sure no water getting in the oil
and not overheating while running, otherwise thinking he might have
done something else to the tractor at the same time. Appreciate any
suggestions on what to check.
 
Back to top
View user's profile
John Saeli
Tractor Guru


Joined: 19 Dec 2009
Posts: 4317


Report to Moderator

PostPosted: Wed May 05, 2021 7:06 am    Post subject: Re: Case 930 hard starting Reply to specific post Reply with quote

This is a tough 1. But, do you really know how hot it got? Air restriction will cause black smoke, but shouldn't cause hard starting unless something catastrophic happened to the air intake. Check that out,; after that do a compression check.
 
Back to top
View user's profile
NFD17
Regular


Joined: 28 Apr 2021
Posts: 39


Report to Moderator

PostPosted: Wed May 05, 2021 9:10 am    Post subject: Re: Case 930 hard starting Reply to specific post Reply with quote

No, I do not know how hot it got, I will get the book and do a compression check, thanks.
 
Back to top
View user's profile
Bruce from Can.
Tractor Guru


Joined: 09 Jul 2009
Posts: 13926


Report to Moderator

PostPosted: Wed May 05, 2021 6:10 pm    Post subject: Re: Case 930 hard starting Reply to specific post Reply with quote

From what you have told us, I cant help but wonder if this stunt might have damaged the valves in the head. There by cutting the compression.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Case and David Brown All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters