Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Case 1730 won't move


 
Post new topic    
View previous topic :: View next topic  
Author Message
Street454
New User


Joined: 05 May 2021
Posts: 1


Report to Moderator

PostPosted: Wed May 05, 2021 5:18 pm    Post subject: Case 1730 won't move Reply to specific post Reply with quote

Hey, folks...I have had this old 1730 for about 4 or 5 years. I use it mostly in the winter for moving snow. I have forks for unloading trucks but not too often...anyway, I have hydraulic pressure to the arms and the bucket. It runs just fine. I just have no forward or reverse. This happened gradually until I had no movement. Plenty of fluid, no leaks. I understand that the drive system is akin to a snowmobile with the friction drive-type system. I took the seat off and saw what I thought was a hydraulic hose dangling in the breeze next to that pulley set-up. I am at a loss, here...I would think if that hose meant something, it wouldn't have taken it's sweet time to get to not moving. This was a couple of seasons in the making. Also, the HI-LO shifter I had to hold in the forward position with my knee in order to keep it in HI mode. Now that isn't a factor any more either...any ideas? Thanks...Mark
 
Back to top
View user's profile
1370rod
Tractor Guru


Joined: 07 Mar 2012
Posts: 5400


Report to Moderator

PostPosted: Wed May 05, 2021 6:30 pm    Post subject: Re: Case 1730 won't move Reply to specific post Reply with quote

With the seat removed start engine and watch the shaft the belt is turning. Move the levers to go forward or back and that shaft should continue to turn, if it does not
the belt is worn and needs replacing and or the pulley needs repair or adjustment . Also that hanging hose might be off the variable speed drive pulley, it pressurizes
the piston in the pulley to increase travel speed. If the drive gradually got worse,, more than likely the belt and or the drive pulleys is where your problem is. If that
shaft continues to turn your problem is in the drive clutches which are contained in the side frames. You have to remove the large side covers to service them, Rod.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Case and David Brown All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters