Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Farmall 656 Floor Pan Removal


 
Post new topic    
View previous topic :: View next topic  
Author Message
big a
Regular


Joined: 07 Mar 2011
Posts: 461


Report to Moderator

PostPosted: Thu May 06, 2021 6:25 pm    Post subject: Farmall 656 Floor Pan Removal Reply to specific post Reply with quote

Only other 656 I ever took the floor pan out of had about an inch trimmed off the right rear corner. Always wondered why until tonight.
Got some wiring underneath I need to get at, so its got to come off.
Got all the bolts out and absolutely cannot get that darn thing forward enough to get the rear of it to come up past that hydraulic manifold block.
Do clutch and brake pedals have to come off to remove this thing?
Seems like that is the only way I am going to get it off.
Cant believe something so simple is kicking me so hard![/u]
 
Back to top
View user's profile
pete 23
Tractor Guru


Joined: 10 Sep 2009
Posts: 7542


Report to Moderator

PostPosted: Thu May 06, 2021 7:51 pm    Post subject: Re: Farmall 656 Floor Pan Removal Reply to specific post Reply with quote

Push the clutch and brake way down, tie them if necessary. Or, you can cut
that little part off before you remove pan. Also, make sure brake lock is
unhooked underneath.

I always modify the pan before putting it back on. You are right, a pain for
such a simple job.

Anther thing I did was get rid of the front hydraulic outlets and pipes. Then
you can make a lot of repairs a lot easier. Need a couple or four shorter
banjo bolts fastening lines to valves.
 
Back to top
View user's profile
big a
Regular


Joined: 07 Mar 2011
Posts: 461


Report to Moderator

PostPosted: Sat May 08, 2021 12:07 pm    Post subject: Re: Farmall 656 Floor Pan Removal Reply to specific post Reply with quote

Thanks Pete!
Glad to know its doable w/o tearing more stuff apart.
I like the idea of removing those front remote tubes, but they are handy for a loader.
You are a wealth of knowledge!
 
Back to top
View user's profile
ejr-IA.
Long Time User


Joined: 19 Oct 2009
Posts: 818


Report to Moderator

PostPosted: Sat May 08, 2021 4:14 pm    Post subject: Re: Farmall 656 Floor Pan Removal Reply to specific post Reply with quote

brake springs
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Farmall & International Harvester (IHC) All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters