Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Things they don't tell you when you split your Fergy


 
Post new topic    
View previous topic :: View next topic  
Author Message
10fingers
Regular


Joined: 06 Nov 2007
Posts: 27


Report to Moderator

PostPosted: Sun Aug 08, 2021 10:31 am    Post subject: Things they don't tell you when you split your Fergy Reply to specific post Reply with quote

See that shaft sticking out of the transmission? Yes the one with a cover you can remove to inspect the race. You mean this........ why are those needle bearings on the floor. How did they get into the bottom of the transmission case and what's that big washer doing down there?
 
Back to top
View user's profile
Tom H.
Long Time User


Joined: 24 Feb 2008
Posts: 1108


Report to Moderator

PostPosted: Sun Aug 08, 2021 11:23 am    Post subject: Re: Things they don't tell you when you split your Fergy Reply to specific post Reply with quote

Welcome to the club!

That just means it was time for a new one.

Tom
 
Back to top
View user's profile
Bruce(OR)
Tractor Guru


Joined: 10 Apr 2007
Posts: 3792


Report to Moderator

PostPosted: Tue Aug 10, 2021 9:55 am    Post subject: Re: Things they don't tell you when you split your Fergy Reply to specific post Reply with quote

If your bored you can come help me overhaul the BW 1356 transfer case that goes in behind the Allison trans that I am waiting for coming from
Florida, that goes behind the rebuilt 7.3 diesel coming from New Jersey. All of that goes on top of the Dana 60 axle getting installed under
some reverse shackles leaf springs as I convert the truck from 2WD to 4WD. Oh, and lets not forget the Eaton Elocker getting added to the
Dana or the overhaul of that entire front axle.
Wanna trade problems?

I won't go into the finer details of the local incompetent diesel shops that gave me 1/2 of those problems. It was just a bad time to loose
an engine and get a knee replaced. We won't speak of the trans. That is another tale of woe.

So, wanna trade?
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Harry Ferguson All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters