Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

starter end play

Post new topic    
View previous topic :: View next topic  
Author Message

Joined: 22 Jan 2001
Posts: 429

Report to Moderator

PostPosted: Sat Jun 30, 2007 3:23 pm    Post subject: starter end play Reply to specific post Reply with quote

Could not find anything in the archives, so, I was wondering if anyone knows what the end play would be on an 8N starter? I have a parts book but have not taken it apart to see if anything is missing/worn out. While I have yet to measure the distance the shaft moves back and forth in the starter housing, it has what I think to be excessive movement which may contribute to the bendix (new) hanging on to the ring gear which is in very good condition. Bendix was unintentally extended using Dell's hairy arm pit method. Wire brush wheel didn't work at all. Thanks, Tom/Idaho
Back to top
View user's profile
dan hill

Report to Moderator

PostPosted: Mon Jul 02, 2007 2:41 am    Post subject: Re: starter end play Reply to specific post Reply with quote

Commutater bars can touch the end plate if thrust washer is missing.Electric motors can fail to start if end play is excessive.Starter repair kits I use have washers in them.
Back to top
Post new topic    Yesterday's Tractors Forum Index -> Ford 9N, 2N, 8N All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters