Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Need help with Long (Allis Chalmers) 445 steering


 
Post new topic    
View previous topic :: View next topic  
Author Message
rudy2
Regular


Joined: 16 Oct 2004
Posts: 82


Report to Moderator

PostPosted: Sun Jul 20, 2008 8:45 pm    Post subject: Need help with Long (Allis Chalmers) 445 steering Reply to specific post Reply with quote

My Long 445 4wd tractor has never steered without a lot of effort. This is the same model as an Allis Chalmers XXX but I forget what model, I am sure someone out there knows this. Anyway, it steers really hard and actually gives me sharp pain in the elbows if I drive it very long. Last year I did a complete overhaul of the steering box because it was leaking gear oil but it did not improve the hard steering. I also did a quickie rebuild of the hydraulic pump and for a while it steered easier but not great. I put a gauge in the pump discharge line and it reads only 500PSI. I also notice that when I clean the suction filter it gets better but still not great. I am wondering now if my pump is shot or maybe the steering cylinder/valve needs attention as it is the only component not messed with yet.

So what do you all think? If I need to replace the pump can someone please tell me what sort of crazy standard it is built to? I have never seen a bolt mounting pattern like that before. Anyone have a good one for sale? I am open to any and all suggestions. (Well, almost all) :-)

Randy
 
Back to top
View user's profile
Bus Driver
Tractor Expert


Joined: 22 Nov 2000
Posts: 3275


Report to Moderator

PostPosted: Mon Jul 21, 2008 3:15 am    Post subject: Re: Need help with Long (Allis Chalmers) 445 steering Reply to specific post Reply with quote

The Allis model is 5040.
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Allis Chalmers All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters