Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

C clutch problem

Post new topic    
View previous topic :: View next topic  
Author Message
pepper boy

Joined: 04 Aug 2004
Posts: 32

Report to Moderator

PostPosted: Tue Jul 22, 2008 4:00 am    Post subject: C clutch problem Reply to specific post Reply with quote

I have an allis c that I have been working on and off with. The clutch rod from pedal to throwout arm was broken off. I welded on a new section but I don"t know exactly how long the total rod should be. It will disengage but it is very stiff pedal and it will grind gears until you get it into a gear then you can move to any gear with no problem. I am not sure if it is a clutch rod length problem or something else. Any help is appreciated. Thanks. Scott.
Back to top
View user's profile

Report to Moderator

PostPosted: Tue Jul 22, 2008 5:44 pm    Post subject: Re: C clutch problem Reply to specific post Reply with quote

Sounds like the throw out bearing is stiff , the pilot bushing is draging ,or the trans just needs to spin down.
Back to top
Post new topic    Yesterday's Tractors Forum Index -> Allis Chalmers All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters