Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

New Project (s)


 
Post new topic    
View previous topic :: View next topic  
Author Message
Erbaugh
New User


Joined: 05 May 2008
Posts: 14


Report to Moderator

PostPosted: Tue Nov 17, 2009 5:08 pm    Post subject: New Project (s) Reply to specific post Reply with quote

Me and my Dad are "red tractor" people, but a co-worker told us to come look at some "old junkers" in their abandoned barn. We found two Case RC's which we're bringing home this Saturday if the rain holds off. I will post some pictures if anyone is interested. I'm not sure of the year of them yet but one is a over-the-top steer model(1935 or 36) and a unstyled side-steer(1937 or 3Cool both on factory rubber. They have been sitting in the barn for at least 30 years but aren't in bad shape. The side steer has a Case rear sickal mower, they also came with a set of front and rear weights for Farmall and a Super C parts tractor. I know these RC's are somewhat rare and I guess you don't find two everyday. They will join our 1940 Farmall A, 1940 Farmall H, 1951 Super C, 1958 Cub Loboy, and 1929 Model A tudor. Looking forward to making these look purty again. I have been doing a lot of research on these tractors. Anyone out there have one or have any tips I need to know about them. Thanks for any responses.
 
Back to top
View user's profile
Alan Golden
Long Time User


Joined: 23 Nov 2007
Posts: 1418
Location: Drumright, Oklahoma

Report to Moderator

PostPosted: Wed Nov 18, 2009 4:41 pm    Post subject: Re: New Project (s) Reply to specific post Reply with quote

The only tip I have is one that you are already aware of since you and your dad are already involved in restorations....be sure to have lots of patience. There may be times you need earplugs so you can't hear some of the words your dad says and vice versa.

Case tractors were overbuilt structurally. Components were heavier than maybe necessary. I have been pleasantly surprised with each of my Case tractors that I worked on. Usually what has needed to be done is just an overhaul.
 
Back to top
View user's profile AIM Address
:   
Post new topic    Yesterday's Tractors Forum Index -> Case and David Brown All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters