Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

VAC 2nd Gear Hard To Shift

Post new topic    
View previous topic :: View next topic  
Author Message
Duane WI

Report to Moderator

PostPosted: Sat Jul 31, 2010 7:22 am    Post subject: VAC 2nd Gear Hard To Shift Reply to specific post Reply with quote

I use my VAC with a 3 pt finish mower. When mowing in second rear and stopping to shift into reverse it almost always is hard to get out of second. If I let out the clutch a little while pulling on the gear shift it comes right out. It will also come out easily if I pull it out while the tractor is still moving forward right before it comes to a complete stop. Without the mower no shifting problems. What would cause this?
Back to top
Paul f
Long Time User

Joined: 11 Oct 2000
Posts: 873

Report to Moderator

PostPosted: Sat Jul 31, 2010 7:31 am    Post subject: Re: VAC 2nd Gear Hard To Shift Reply to specific post Reply with quote

I have a 6ft finish mower on my VAC. Whenever I stop I always step on the brakes that seems to stop the gears and allows me to shift immediately. If I coast to a stop after stepping on the clutch I have to wait for the gears to stop spinning. I do not have an overrunning clutch on the mower. That might make it easier for you.
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Case and David Brown All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters