Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

oil pan 430

Post new topic    
View previous topic :: View next topic  
Author Message
sam un ont

Report to Moderator

PostPosted: Tue Apr 12, 2011 11:53 am    Post subject: oil pan 430 Reply to specific post Reply with quote

my 430 seized up so i removed the starter and tried moving it with a pry bar and found that i was able to move it but once it it a certain point i would hear a noise from the rear of the engine. pulled the plugs and put a rod in reach cylinder and rotated the motor and found that #4 piston was not moving. what i suspect is that either the rod snapped or the bearing cap. is there any way to remove the pan without taking half the tractor apart. it does have a front end loader sam
Back to top

Joined: 19 Sep 2007
Posts: 43

Report to Moderator

PostPosted: Tue Apr 12, 2011 12:28 pm    Post subject: Re: oil pan 430 Reply to specific post Reply with quote


I don't see what's to be gained by just removing the oil pan at this point.

Remove the loader
Remove the front end
Remove the engine
Disassemble, inspect repair and replace as needed.

Who knows what else is damaged in their when and engine stops that fast.

Just my thoughts

Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Case and David Brown All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters