Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

allis190


 
Post new topic    
View previous topic :: View next topic  
Author Message
Rich in md
Guest






Report to Moderator

PostPosted: Tue Jun 14, 2011 4:46 pm    Post subject: allis190 Reply to specific post Reply with quote

Allis 190 power steering, does it run off the main hydraulic system or is it a stand alone system?? I" not familiar with an Allis 190 and for the life of me I cannot find where to find any dip stick or fill points, I have no manuals, belongs to our local fair grounds and no one knows anythings about it. appreciate any help. Thanks
 
Back to top
JMS/.MN
Tractor Guru


Joined: 05 Mar 2009
Posts: 12827


Report to Moderator

PostPosted: Tue Jun 14, 2011 4:55 pm    Post subject: Re: allis190 Reply to specific post Reply with quote

Can you trace down a previous owner for advice or books? Seems the fair board should see the value of spending a few bux to maintain a valuable machine. $20-30 for the basic op manual, which has the info you need.
 
Back to top
View user's profile
Jim Plunkett
Regular


Joined: 01 Sep 2008
Posts: 206


Report to Moderator

PostPosted: Tue Jun 14, 2011 5:20 pm    Post subject: Re: allis190 Reply to specific post Reply with quote

A little humped plate behind your feet when sitting on the seat 2 bolts hold it on
 
Back to top
View user's profile
Rich in md
Guest






Report to Moderator

PostPosted: Tue Jun 14, 2011 5:31 pm    Post subject: Re: allis190 Reply to specific post Reply with quote

thanks
 
Back to top
180doug
Regular


Joined: 07 Oct 2007
Posts: 312


Report to Moderator

PostPosted: Wed Jun 15, 2011 2:36 pm    Post subject: Re: allis190 Reply to specific post Reply with quote

As you sit on the seat the right stick is for Transmission ; the one on the left is a screw in type and is the hydralics ; go to Un officialallis .com and get on the discussion board and post the problem you are having , alot of AC knowledge on there , they will help you out !!
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Allis Chalmers All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters