Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

7045 power shift pedal adjustment


 
Post new topic    
View previous topic :: View next topic  
Author Message
ACBILL
Guest






Report to Moderator

PostPosted: Sun Jun 12, 2011 12:26 pm    Post subject: 7045 power shift pedal adjustment Reply to specific post Reply with quote

My 7045 power shift clutch pedal is just about all the way out before the tractor will begin to move. Sometimes I have to reach down and pull up on it to get the tractor to move. The pedal spring is good. Its like it needs adjusting. Can it be adjusted and how do I do it? Thanks for your help. Bill.
 
Back to top
jim_from_uny
Regular


Joined: 03 Jan 2011
Posts: 25


Report to Moderator

PostPosted: Wed Jun 15, 2011 2:28 am    Post subject: Re: 7045 power shift pedal adjustment Reply to specific post Reply with quote

per itt manual. adjust york (Y) until a clearance of 0.001 - 0.020 inch is obtained between inching spool lever and inching spool at point c. release inching pedal and adjust pedal return stop screw until a clearance of 0.10 - 0.30 inch is obtained between inching spool lever and inching spool at point c with incing spool held in against it internal stop. pedal return stop screw may be reached by removing engine side cowling cover and insulation blocks, then reaching in from top.
shoot yur email & i have scan for you
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Allis Chalmers All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters