Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

waterpump 861 ford

Post new topic    
View previous topic :: View next topic  
Author Message
gary belote
New User

Joined: 05 Mar 2009
Posts: 8

Report to Moderator

PostPosted: Mon Oct 29, 2012 4:03 pm    Post subject: waterpump 861 ford Reply to specific post Reply with quote

My manual says to change pump...loosen belt and remove the belt. Therein lies the rub. The belt will not pass between the end of the crank and the crossmember. There is a plate about 1/2" thick bolted on front of the bottom pully with 4 bolts. What happens if I take them loose? Need help from one of you knowledgeable guys.
Tks Gary
Back to top
View user's profile
Tractor Guru

Joined: 12 Mar 2000
Posts: 79557
Location: Lake of the Ozarks area of MO

Report to Moderator

PostPosted: Mon Oct 29, 2012 4:27 pm    Post subject: Re: waterpump 861 ford Reply to specific post Reply with quote

Remove the fan blades and then you can get the belt off the water pump pulley to change the pump. By the way the belt will if you do not have a loader fit between the frame and the crank pulley but it is a real tight fit and a real pain in the back sides. Of course what it sounds like you have is a tractor that had a loader on it and that plate is the hyd pump drive spline hub and if so yes you have to remove that
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Ford All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters