Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

I give up, I'll use what I have.

Post new topic    
View previous topic :: View next topic  
Author Message
Richard from SE AZ
Long Time User

Joined: 21 Aug 2007
Posts: 1251

Report to Moderator

PostPosted: Wed Nov 14, 2012 2:05 pm    Post subject: I give up, I'll use what I have. Reply to specific post Reply with quote

I have been looking for a front mount N motor for a couple of years. None to be had anywhere close to AZ. I found one on the East coast but shipping was hard to believe.Even from as close as Idaho shipping is high. I bare block 80 miles from where I live that I could go get was $500. I couldn't even find anyone that would trade for a side mount in good shape.Sooo, I guess I will use the motor that came with the tractor. I bought it as stuck but the problem was a piece of starter drive stuck between the housing and the ring gear. I didn't want to use it cuz it had been cracked and JB welded. I will clean up the old JB and redo it. I need the tractor so I can put a loader on it(I already have the loader) for occasional use. Prices for old fords around here are PRETTY high.The tractor was really cobbled up.Good winter project. Gonna start after Thanksgiving.
Back to top
View user's profile

Joined: 10 Jun 2011
Posts: 31

Report to Moderator

PostPosted: Wed Nov 14, 2012 2:26 pm    Post subject: Re: I give up, I'll use what I have. Reply to specific post Reply with quote

There is a front mount block on Ebay now (not mine) with 65.00 shipping. Just FYI
Back to top
View user's profile
Post new topic    Yesterday's Tractors Forum Index -> Ford 9N, 2N, 8N All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters