Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

'94 GMC


 
Post new topic    
View previous topic :: View next topic  
Author Message
CH(upstate,NY)
Regular


Joined: 14 Dec 2007
Posts: 471


Report to Moderator

PostPosted: Mon Dec 31, 2012 11:55 am    Post subject: '94 GMC Reply to specific post Reply with quote

After finishing plowing to my equiptment shed so I could get my loader tractor out last night, I parked my truck at my shop to grab some parts, Came out 15 minutes later and the engine spun fine but wouldn't start. Thought I might have gotten snow on the distributer. It's a '94 sierra 350. I put an old plug on one of the leads and have spark, weak but if you saw the plug I used. I checked the inj and ign fuses and they're good. I don't smell any gas. I tried to hear a click while turning the key and couldn't. And I can't find my service manual.
Which line going into the throttle body in gas from tank? I'd like to lossen it and see if I'm getting gas.

Appreciate any help. It's cold out there.

I posted this on Tracter Talk too.
 
Back to top
View user's profile
Paul Janke
Long Time User


Joined: 27 Nov 1998
Posts: 965


Report to Moderator

PostPosted: Mon Dec 31, 2012 1:16 pm    Post subject: Re: '94 GMC Reply to specific post Reply with quote

Starting fluid (WD40 works well) will let you know if you have spark so you can narrow down the problem.
 
Back to top
View user's profile
Glomus
Guest






Report to Moderator

PostPosted: Mon Dec 31, 2012 3:31 pm    Post subject: Re: '94 GMC Reply to specific post Reply with quote

Go change the cap it burned through again. I just did on mine, and this time you couldn't even see where it happened. I chose delco stuff from amazon cheaper than junk from the auto parts store for more.
 
Back to top
Bob Huntress
Long Time User


Joined: 27 Dec 2007
Posts: 1240


Report to Moderator

PostPosted: Mon Dec 31, 2012 10:25 pm    Post subject: Re: '94 GMC Reply to specific post Reply with quote

While I have my reservations about WD40, Paul is right on about using starter fluid to see if it fires and quits. If it does fire and quit with ether, you aren"t getting fuel and should go over your ignition.
 
Back to top
View user's profile
wilson ind
Tractor Expert


Joined: 16 Dec 2011
Posts: 3148
Location: linton indiana

Report to Moderator

PostPosted: Tue Jan 01, 2013 1:02 pm    Post subject: Re: '94 GMC Reply to specific post Reply with quote

Had corvette due that was timning chain and pladtic gear never started till new timing set
 
Back to top
View user's profile
CH(upstate,NY)
Regular


Joined: 14 Dec 2007
Posts: 471


Report to Moderator

PostPosted: Wed Jan 02, 2013 1:32 pm    Post subject: Re: '94 GMC Reply to specific post Reply with quote

I bought a can of starting fluid on my way home today. Sprayed some in the throttle body and it started and ran fine. Go figure. Waited a half hour and tried again and it fired right up.
 
Back to top
View user's profile
Determined
Tractor Expert


Joined: 26 Dec 2012
Posts: 1540
Location: N.W.Saskatchean

Report to Moderator

PostPosted: Thu Jan 03, 2013 6:56 am    Post subject: Re: '94 GMC Reply to specific post Reply with quote

You may have a faulty fuel pump relay, but most likley your electric in tank fuel pump is on it's way out.
Dave
 
Back to top
View user's profile
:   
Post new topic    Yesterday's Tractors Forum Index -> Tool Talk All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters