(800) 853-2651
SHOP NOW

Recent content by JerseyJoe

  1. J

    Bolens Contacts and Info

    I just checked Ebay and there's a clutch listed for your tractor.
  2. J

    MF 285 3pt lift arms

    The 285 I rebuilt the three point on at the Massey dealership surprised me,the three point control worked opposite of your 231.
  3. J

    MF 1020 3point no workie

    Under the front of the seat is a knob,someone may have turned it in,try to unscrew it.You may need some penetrate to loosen it if it hasn't been turned in while.
  4. J

    MF 1020 3point no workie

    Good morning, Where you capped the fittings at the tractor may be your problem.Remove the caps and replace with a hose connecting them together,right now the oil has no wheres to go and you are just overheating the oil dead heading at the relief valve.
  5. J

    Bolens Iseki g154 2 cylinder need help with a busted PTO

    Hope this helps,there is a service manual on Ebay for the G154.
  6. J

    Another MF 383 question

    In the parts book,go to the front axle and you will find the tandem pump. Joe
  7. J

    John Deere gator head gakst

    John,need a little more information,there are several models considered Gators.Can you post the make,model,spec and serial number of the engine. Joe
  8. J

    Massey 44 overhaul gasket numbers?

    '87 FelPro catalog,can't find H260 under Massey,Continental lists H260. head set- HS 7624 B full set- FS 7624 B oil pan set- OS 5741 D rear main set after eng 38328 bolt on- BS 14369 valve cover set- VS 5730 Hope this helps, Joe
  9. J

    MF-1035 hood

    One lever is for the Hi-Low-Medium,the other lever is for the four wheel drive.On the hood,push the knob in with one hand and bump the hood in the middle, straight in from the knob with your other hand.
  10. J

    AD3-152 question

    Dennis,You're quite welcome and thank you for posting back.Joe
  11. J

    AD3-152 question

    If the new spacer fits the crank and is only about a 1/4" wide and the same thickness,that replaces the large oil slinger.That new spacer has a smaller outside diameter to allow engine oil to reach the seal to cool and lubricate. Joe
  12. J

    35 deluxe oil passage

    Then the rear main bearing is not installed correctly.
  13. J

    35 deluxe oil passage

    Did you take the oil pressure gauge fitting out of the block ?
  14. J

    35 deluxe oil passage

    Short answer-head gasket installed upside down,long answer-oil galley is front to back on right hand side of block,at the back of the block the galley is cross drilled left to right and supplies the rear cam journal AND upward to cylinder deck to supply pressure to rocker shaft. Joe
  15. J

    Planter FEED SPEED

    seed knocker in working order ?
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top