(800) 853-2651
SHOP NOW

Recent content by Mike in MI

  1. M

    Case 646

    Tom, Leave it to me being cofussed on the rotation on these pump to engine setup. my problems was on how you was looking at it at the time. i got back with the source where I bought the pump and asked if they had the same setup but with a CCW rotation. I will call them tomorrow as it was too...
  2. M

    Case 646

    It's been a while since I posted on yesterdays tractors about my Case 646 problems. I've been in an out of the hospital this past few months just have'nt had the time or streight to do anything. Since last time I posted on here I was having hydraulic pressure problems on my 646. I ordered a new...
  3. M

    Oliver Super 77 brake problem

    Here some what the springs look like and a good place to order them they will also have disc brakes and other parts for the olivers. Here in Michigan it's getting harder to find a place that carries Oliver parts anymore. Good luck on your Super 77. brake spring
  4. M

    Oliver Super 77 brake problem

    2underage, I'll try to give you answer on the disc brake sticking. On my super 77 I had same problem. Theres are 3 tention springs attached too disc actuators. The springs over a period of time get stretched from heat and use. Once you get the outer plate off you can see the assembly. There are...
  5. M

    Tom, Kencombs update -Case 646 compact loader

    I finally figure out on the hydraulic pump off 646 what direction too go by. The center plate or body has 2 arrows I didn't see the secound one (too much paint). Looking at the shaft side of pump up right the arrow shows it turning CW but if you was too turn pump 180 degress looking at it upside...
  6. M

    Case 646 compact loader (Questions)

    Looking AT the shaft end on the pump the arrow on the back pointing counter clockwise rotation, then if you turn the back side of pump looking at the arrow from the backside of pump it shows it going ccw. I'll try taking some pictures of this pump I have. If the pump shaft an crankshaft are...
  7. M

    Case 646 compact loader (Questions)

    Ok, this is what I found so far dismantling the pump. The pump looks to me to be a pump from a 644? Looking at a parts breakdown between the 644 & 646 it looks like the same pump as the 644's. I'm not sure what the pressure ranges on 2 are if any? Kencombs your are right taking a guess on the...
  8. M

    Case 646 compact loader (Questions)

    Tom, I've had all three cylinders apart to put new oil seal kits in. I think the loader tractor has set for a few years even before the other owner had it. All the oil seals/O'rings on all 3 cylinders was cracked or dry rotted. I Also found the travel valve & loader contol valve o'rings hard an...
  9. M

    Case 646 compact loader (Questions)

    I bought a 1972 Case 646. It didn't have an engine when I bought it. Other owner said it had the CCKA 16.5 onan in it. Engine was bad an the cost too rebuild the old one he lost interest in it. I'm slowly getting it back togther. I had another onan engine from a JD 420 with the P220 and I just...
  10. M

    Direct TV and fed up with all the comercial time

    I feel the same way! There all a bunch of rip offs far Im concered. I think I heared the other day a person say we interuped this commercial to bring back to you program. Some channal my wife was watching.
  11. M

    Coyotes are back!

    Been seeing them all summer long here. Was told DNR turned some loose like they did the wild turkeys the year before.
  12. M

    compresson on 14hp Kolher

    Hi Tom I learn't something again today from you as I alway woundered how to check the compression on a 14Hp engines too. Thanks
  13. M

    Ready for the snow I think?

    Josh is probably right since I went thru the trouble it hooking it up it will go around. Thats ok. rrlund, you may seen some your way. I guess they said it going to track along turnpike.Josh you may see some too? Wished I had a heater. Probably be high winds along with the snow too. Heat houser...
  14. M

    Ready for the snow I think?

    J. Schwiebert, I'm not that from you. Just north of Ohio/MI line a few miles. Just off US 127 about a mile near Lime Lake.
  15. M

    Ready for the snow I think?

    Put the snow plow on 880 this afternoon. They say we could get up to 6" to 12" or more here in SE lower MI. Maybe we will get lucky and it will go around us.
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top