Search results

  1. M

    Tow a Honda Rancher?

    The Honda Rancher automatics still have a neutral shift position so it should not hurt anything.
  2. M

    Bobcat 310 371 440 mini skid loader

    I don't know of any aux hydraulic kits. It would probably have to be a on your own deal.
  3. M

    Bobcat 310 371 440 mini skid loader

    We had a Bobcat 440b for years and was absolutely trouble free. A great machine for its size.
  4. M

    Alternator Confusion, Positive Ground

    The Brillman Company that advertises in Red Power Magazine sells a positive ground alternator.
  5. M

    1936 Farmall F20 engine rebuild sleeves

    any good machine shop can bore the sleeves and put a sleeve in the sleeve.
  6. M

    Friday Extra 4

    It looks like it says case on the frame just below the front of the engine.
  7. M

    Power lift on F14 tractor

    The lift systems on the f-12/f-14 tractors do need a thick oil in them. I have always used 85/90wt. oil in mine as well.
  8. M

    Bummed out

    You guys need to read what he wrote better. He said it started to back it off the trailer at his place, so the elevation has nothing to do with it, then died, so the problem has to be a fuel restriction.
  9. M

    W9 radiator weight

    There are two different radiators in w9s. A light one and a heavy one. I would say the light one is probably 40-50 lbs. The heavy one is closer to 200-250 lbs.
  10. M

    Tractor picture

    It is a International 15-30 Flaming Four!
  11. M

    Adding a hour Meter

    Why not just get an induction type hour meter? You can get them for $10 off of Amazon and are easy to install. Just rap the induction wire around the coil wire and it senses the power impulses and starts counting hours. No worry about counting hours leaving the switch on. It won't count them.
  12. M

    Farmall regular piston removal

    No, there is enough room for the piston to come past the crank without removing it. It just needs to be turned to the side.
  13. M

    Identify a tractor?

    The front wheels with the tapered bearings have a much larger center hub in them that the spokes fasten too.
  14. M

    Identify a tractor?

    It is an early IH 15-30. From 1921-1925 they had the roller bearings in the front wheels instead of the later tapered bearings. So this one is from 1921-1925.
  15. M

    560 glow plug

    My 560 recently had a burned out glow plug, I replaced it with one I purchased from Case-IH years ago and have kept on hand for a spare. When I went to warm the glow plugs to start it after the replacement after about 15 seconds with the glow plugs on there was a small pop in the exhaust and...
  16. M

    What does T-20 mean

    The T-20 engine is different. It has the same bore and stroke as a F-20 but has a water pump like the F-30. The valves are different between a F-20 and a T-20. Shorter I think.
  17. M

    How to clean tractor without using water?

    The picture does not look like water damage to me. It looks like a bearing went out which happens with time and use and you had trouble getting it apart which also comes with time and maybe it would have helped the situation if you would have washed off the grass clippings and such so it would...
  18. M

    Magneto issues

    make sure the mounting area is clean so the magneto is grounded to the frame.
  19. M

    Front End Clunk

    It could be the outer axle pivoting forward and back in the inner axle if the bolts are not tight enough. The pin through the axle keeps it from going too far but wears over time and starts to move more and make more of a clunk as it does.
  20. M

    4020 rear weights

    I need to mount some rear wheel weights on a JD 4020. Are the hole 5/8" or 3/4"? I don't have the tractor close to check or I would measure myself. Thanks.

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top