(800) 853-2651
SHOP NOW

Search results

  1. K

    I'll try a Puzzle

    Try at Grandpa Love's puzzle Grandpa Love Pic
  2. K

    Oliver 1650 Plugs Wires?

    Autolite specifies #66 Spark Plug for light service. This is a resistive plug. The tractor has resistive plug wires. Is a resistive plug with resistive wires too much resistance? The tractor currently has #65 plugs which carbon up. Hoping using #66 with help reduce carbon buildup. Thanks, KMo
  3. K

    Try Again

    JD Dain Puzzle
  4. K

    Puzzle I'll give it a try--

    The JD Dain The Froelich Tractor Museum looks very interesting. https://www.froelichtractor.com/ If this works there will be a puzzle. K-Mo JD Dain Puzzle
  5. K

    Oliver 1600 Head Gasket

    Oliver 1600-- Keep receiving aftermarket head gaskets with the fire rings falling out of the gasket. The old gasket and any gasket I've seen from my old days, the fire ring was part of the head gasket. Are these defective gasket sets or is it a different way to seal the cylinder? Anyone have...
  6. K

    Question for Oliver 1600 Head Gskt Expert

    Helping a neighbor R&R head for a valve grind on an Oliver 1600. Everything lines up to be a stock Oliver 1600 Gas. Except it has 3-7/8 sleeve and pistons. I believe this to be a 1650 diesel bore. Block number 155119 Question-- Will this overbore use the standard head gasket be should a diesel...
  7. K

    What is it?

    Any ideas on what this California piece may be part of?
  8. K

    Shop Rates

    I was reading a post about cost of dealership repairs. People think they are getting ripped off. I agree. I worked for an IH dealership in the 1960s & 70s. Shop rate was $5.00/hr. Putting $5.00 through the government inflation calculator equates to $36.55/hr in 2020 dollars. Corn price in 1969...
  9. K

    Did CASE make Truck Farm Equipment?

    In the past, most major manufacturers built equipment for growing vegetables. Most were offset like the Farmall Cubs and As. Allis had the "G". CASEIH and JD still had offsets in the 90s. I don't recall any CASE equipment.
  10. K

    Farmall Land USA

    Last season for Farmall Land USA. Farmall Land USA
  11. K

    350U 504U Main Clutch

    Have an issue with the main clutch on both 350U and 504U. Doesn't seem to have enough pedal travel. Next to no free pedal and the clutch will release only at the very bottom of travel. If clutch free travel is adjusted to the prescribed 7/8" to 1-1/4", the clutch will not release. When the...
  12. K

    Rusted Fuel Tanks

    I have severely rusted fuel tanks on Briggs & Stratton engines on equipment that sat outside for a couple of years. The kind with the carburetor mounted on the fuel tank. To replace a tank, I went to my salvage pile and pulled out a couple of engines that had been in the pile for several years...
  13. K

    Aspinwall Potato Planters??

    I would like to communicate with someone familiar with Aspinwall potato planters. I have been asked to help someone with an Aspinwall. Basically need to reconstruct the feed and flow regulation. My experience is mostly McCormick Deering.
  14. K

    LANAGAN 444 Armature Growler

    I have a LANAGAN 444 Armature Growler I would like to sell. But, I don't like the way the "SHORT" Test Light is wired. 115VAC is connected to a 25W bulb. The test lead comes off the other side of the bulb. When the lead touches the other probe or the case(Ground) the test light lights. It has a...
  15. K

    JD 272 Grooming Mower Info?

    I need to fabricate a top link clevis for my 272 Mower. Ref. #3. I would greatly appreciate it if someone could provide the center to center distance between the holes. Thanks, K-Mo
  16. K

    Cranks But Won't Start

    Lessons Learned-- Yesterday I went to the machine, shed cranked up the little Mustang 310 skid loader to move some wheel weights. Shut it off and loaded the weights. When I tried to start it again, it cranked right over, but no fire. Tried to prime with some gas, no go. Pulled the spark plug to...
  17. K

    Re:

    On mine it was 1 & 4 rod bearings. I found it interesting that 2 & 3 were good since oil has to go through 1 & 4 to get to 2 & 3.
  18. K

    McCormick No. 25 Potato Planter??

    I have a McCormick No. 25 Potato Planter I'm trying to get operational. I'll start with two question for today. The covering disc down pressure spring free length is about 10". Someone has added about 2" of spacer at the top. Spacer not shown in OM or PM. 1. How long should the covering disc...
  19. K

    Farmall 140 Top Radiator Hose

    Looking for correct aftermarket top radiator hose for a Farmall 140 (P/N 369397R1). Most aftermarket 369397R1 hoses do not fit. CaseIH hose IDs are 2-3/8" and 2-1/2". Many aftermarkets IDs are 2" and 2-5/8".
  20. K

    Oliver Potato Planter

    I have what appears to be a Superior/Oliver Potato Planter, but can not find any printed information such as Operators and Parts Manuals. Would anyone have any information to share?
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top