Search results

  1. T

    420 starter

    Thanks I will check it out if it sticks again. I am also working on a 40 with front and back cultivators don’t see many around here either the cultivators are the plentiful elsewhere
  2. T

    420 starter

    Thanks for the help the starter was stuck I loosened the starter and pulled it back a little and it spun over and put it back and it turned over fine thanks again
  3. T

    420 starter

    The John Deere 420 cranked fine last week and this week it will not turn over and the starter switch on top of the starter gets hot and smoking when you pull the starter rod to start the tractor. What could be causing this to happen, thanks in advance
  4. T

    Rivet pin

    Thanks for the help in finding the rivet pin for the reverse gear in my 140. I got it in but having a hard time mushrooming the pin I can not hold the bottom enough to flatten out the top. I was wondering if anyone new a tool I could use or a trick to do that thanks
  5. T

    140 reverse gear pin

    I got the reverse pin out I ground the top off and drove it through now I am ready to reassemble the transmission. Are those pins available if not what would be good to put back there Thanks for the help
  6. T

    140 transmission

    I am changing a broke counter shaft in my 140 and the 3 and 4 slide gear. The top shaft has a pin on the reverse gear that is not in my manual and I can’t slide the shaft out. I have an arrow pointing at the pin and I am not sure if it is one pin or two one on each side of the shaft. Does anyone...
  7. T

    140 transmission

    Thanks for the help I found some used ones local at Burch store tractor about an hour away from me and they have a large selection of Farmall stuff
  8. T

    140 transmission

    Can I buy a new counter shaft and 4th gear for my Farmall 140 and if so where can I get that
  9. T

    4600 England Style

    Have a few questions, I am going to change the fluid in my 4600 on two of the pics I have drew in where I put the new fluid in and fill up to the plugs I have marked. Does that look correct. I also have a power steering leak were it comes out at the steering wheel. I had a local tractor guy to...
  10. T

    4600 hydraulic fluid change

    I changed the fluid on my 4600 and the person at the New Holland dealer said it took around 3 gallons for the transmission and 8.5 for the rear. I put around 3.5 gallon in the transmission to get it to the only line on the dip stick (see pic) I put 9 gallons in the rear and it never came out the...
  11. T

    4600 England Style

    The serial number I had the pic of was that the entire number? Thanks for your help
  12. T

    Farmall 140

    How much play should the axle shaft have pushing in and out. I have a knocking in the left wheel and when I took the final drive out the bearing will go on and off with no problem and I had at least a quarter inch play in and out. I was going to press the bearing back on but I am not sure if...
  13. T

    Farmall 140

    Thanks mine does have the sprocket hub and I pressed that bearing on the axle and put it all back together and it took the play out. Hope to put it back on the tractor this week and see if the noise is gone. The guy I bought it from said his foot slipped off the clutch and after that the...
  14. T

    Knocking in left wheel

    They seemed ok but I have bought new ones when I put it back together to be sure. The old ones was worn a lot thanks
  15. T

    Knocking in left wheel

    The left hand axle shaft had about a quarter inch play in and out that I thought would be my problem. I removed the final drive and took the shaft out and everything looks ok and nothing missing I was wanting to find a broke washer in the oil pan what would cause that play in and out and...
  16. T

    Knocking in left wheel

    I did not have to use a puller to remove the axle shaft bearing like the book said could that be the reason for the play back and forth and the noise in the wheel when moving
  17. T

    Knocking in left rear wheel

    I was not so lucky to have a loose wheel! I figured out the knocking noise is happening when the tractor is pulling in the forward direction. I can push the clutch in and it stops with the tractor still going forward and it will stop if I am going down hill and the tractor is not pulling and it...
  18. T

    Popping in left rear wheel

    Previous owner of a farmall 140 let his foot slip off the clutch and he said that is when it started making a popping noise in the left rear wheel when tractor is moving. Any idea what that noise could be. Thanks

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top