(800) 853-2651
SHOP NOW

Search results

  1. T

    Intermittent spark from magneto

    3 two zero 2 nine 3 5 zero zero 5.
  2. T

    Intermittent spark from magneto

    If you need help on the mag, I do them as a hobby. I have the testers that takes the guess work out of it. Also have a magnet charger that gets the magnet up to snuff for a good hot spark.
  3. T

    1947 Farmall A

    I am looking for a plow for my Super A if anyone has one for sale.
  4. T

    D19 distributor

    What is worn out? Why can't it be rebuilt?
  5. T

    These little kids are gonna be a problem

    Tastes worse than bad venison!
  6. T

    Dowsing Rods

    Around here in mid Mn. there are no clues as to where there is or is not underground water, but the dowsers can find it. A deceased friend of mine used just one bent wire. It would show him wich way the water was flowing underground. He followed a vein through some strange woods & found a...
  7. T

    Dowsing Rods

    So just what are controlled conditions?
  8. T

    Dowsing Rods

    If you have 2 people & one has the knack, just use one rod in the left hand of one & the other hold his with his right hand Then join hands right & left & try it. It will work for both & after that chances age good it will work for both.
  9. T

    Son has a front mount that has been converted to 12 volts. It has 2 resistors before the coil but it burns the points in about 2 hours of running.

    I would say series as it goes from one to the other.
  10. T

    Son has a front mount that has been converted to 12 volts. It has 2 resistors before the coil but it burns the points in about 2 hours of running.

    That is good to know. Thanks.
  11. T

    Son has a front mount that has been converted to 12 volts. It has 2 resistors before the coil but it burns the points in about 2 hours of running.

    It had 2 long white resistors & I changed one with one I had that had more resistance. It was converted when he got it & always had problems. Condenser checks out to be good with a good condenser tester. If he still has trouble I will get the original one for behind the dash. This site shows...
  12. T

    Son has a front mount that has been converted to 12 volts. It has 2 resistors before the coil but it burns the points in about 2 hours of running.

    Son has a front mount that has been converted to 12 volts. It has 2 resistors before the coil but it burns the points in about 2 hours of running. When he turns on the ign switch the ampmeter shows a 10 amp discharge. We changed one resistor to a higher value but it still shows 10 amps...
  13. T

    Farmall C kicks back when starting

    You may have to send that mag to me so I can try & fix the impulse.
  14. T

    12 volt generator

    If you get some leads about 20 feet long to get that tester away from the generator it might work.
  15. T

    Tool Wars

    Large cast iron jointer with 12 inch knives. It had a 5 HP 3 phase motor on it when I got it. Now has a 3 1/2 Hp 220. I ran it with a 2 cylinder Wis for a while when I 1st got it. Close to 8 feet long.
  16. T

    1929 Farmall regular, serial # 50570

    If the mag needs help, I just got done with one like it yesterday.
  17. T

    dying 1020

    Has the condenser been tested after it has been warmed up?
  18. T

    M rings

    Those bearings are imbedded with dirt. Replace them. Make sure you clean up everything. Check the mains & if they look like the rods, replace them too. Clean out the holes in the crank too.
  19. T

    John Deere m

    Was the oil milky? Maybe antifreeze caused the bearing wear?
  20. T

    Am I the only one that ''Boils a Carb"?

    I boil the cast iron ones in lye water.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top