Hello, was wondering if anyone could answer a few questions for me on my hydraulic pump. 1. Is it a Thompson or a Pesco? At first I thought it was a Thompson by the cap style, but after working the paint off to read the part # I'm almost sure it's a Pesco, just not a 100% The gasket kit for Pesco lists for part#s 355007R91, R92, and R94, but mine looks like it has 355007R93 in one pic. In another pic I took it looks like a 2 stamped down. #2 question is my shaft worn down enough to need a Speedi sleeve? I used a digital caliper and measured the shaft at .624 inches at normal and .620 inches where it's worn. Just not sure if that .004 in. Is enough wear to leak fluid into the oil pan. My pump has the o ring style and not the shaft seal. Also, I changed the oil prior to taking of the pump and noticed quite a bit of oil more than 5 quarts and that was before researching and finding out that a leaking pump can fill the oil pan. When I drained my touch control block, after it wasn't working there was only around a quart of hydraulic fluid that came out. Thank you to in advance to anyone that can help me on this. Mitchell