John deere 60 hydraulics

[Snuffbandit]

Have a 1953 john deere 60, power trol, 3pt
1 remote. I was going to run a NH 488 with.
Not enough pressure to run lift the mower
up. Attached is a picture of the hydraulic
remote setup, I'm assuming g it's getting
full pump pressure from where the pressure
line from the pump runs. Pulled the pump
and it's get some bad scoring on the plates
and gears causing the 800psi reading I got
in testing. Any good sources for getting
good used pumps or parts the rebuild mine?

Note. Remote is plumbed into a plate
between the differential housing/power-
troll housing.

 

[BillinCentralMO]

Where are you located ? There is an ad on Craigslist out of French Village , Mo that he is parting his out. Thats about an hour south of St Louis. Good luck.

 

[DRussell]

Are you running it off the tractor hydraulics or that PTO hydraulic pump? I would think the tractor hydraulics would have enough pressure to lift a haybine. We had a JD 60. It would lift a 477 haybine and a 494 4 row planter loaded with fertilizer and corn.

 

[Snuffbandit]

Pto pump is for front loader. I'm trying to run off the live hyd.

 

[Snuffbandit]

Central mn

 

[rufus80]

Factory pressure on a 60 was 850-900 psi for an early one on up to 1100-1200 psi for a late model. You can adjust the relief pressure by adding shims to the relief. The easiest thing to do is put a bigger cylinder on the mower.