(800) 853-2651
SHOP NOW

Search results

  1. E

    John Deere plow

    It's a 52 or a 4B plow. Show us a picture of the hub cap on the furrow wheel. A 52 has a flat cap held on with 3 bolts. If you measure from the tip of the point to the bottom of the frame it is 21" on a 52 and 23" on a 4B.
  2. E

    Popping

    Lean fuel mixture
  3. E

    John Deere plow

    Yes you have a 44.
  4. E

    JD40 VR removal

    It's hard to get at, be patient.
  5. E

    JD40 VR removal

    Do you have the hood and side panels removed? Keep soaking the rusty screws with pb blaster or something similar.
  6. E

    Identifying an old plow

    It's a case plow. No idea what model.
  7. E

    McCormick MFF Grain Doll

    Spider cobwebs will plug the grass seed drop tubes. Clean the tubes with compressed air and a blow gun.
  8. E

    720 john deere

    Check the chassis ground.
  9. E

    JD 620 Steering catch issue

    I think you are fine. There are 2 dowel pins pressed into the outer sleeve. Did you happen to check them for flat spots. If they have flat spots punch them out and flip them over.
  10. E

    JD 620 Steering catch issue

    In the front of the worm gear there is a bushing that has an internal and external thread on it. There is a locking plug inside of it that is loosened with an Allen wrench to adjust the bushing. With the bushing removed pull the internal threaded piece forward. Start the bushing into the worm...
  11. E

    JD 620 Steering catch issue

    Is your 620 a black dash late model?
  12. E

    JD M stalls

    What do you see in the sediment bowel? Your gas may have moisture in it. When you drain the carburetor you remove the water that settles to the bottom.
  13. E

    Any info on this tractor?

    John Deere's model year ran from October to October. Some serial number charts use this chart and some go by calendar year.
  14. E

    Any info on this tractor?

    Pressed frame B's were built from 48 to 52. The rear axle housing was changed from round to square in 1950.
  15. E

    What would this plow be called or classified as ?

    It's a disk tiller. The disks are mounted on a common shaft. A disk plow has each disk mounted on it's own stub shaft.
  16. E

    JD disk plow

    Maybe a 400 series
  17. E

    New Holland Baler, changing from sisal to plastic twine

    Is the twine knife sharp? The wiper arm should contact the bill hook lightly to scrape the knot off.
  18. E

    1520 Gasser

    Actually the function of the solenoid is to prevent the engine from diesiling when its shut off by cutting off the gas flow to the hot cylinders.
  19. E

    Barn Cleaner Drive Sprocket Bolts

    We used grade 5 in ours
  20. E

    John Deere 14-in share Syracuse number x1450F looking for part

    Yes, a 1450 bottom was sold as a 16" bottom and a 1451 bottom was sold as a 14" bottom. Both bottoms are exactly the same other than the number cast into them. Why they did that I have no idea but they are good bottoms and very popular. Parts are hard to find because farmers hung onto them till...
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top