Recent content by 02WS6SSZ71

  1. 0

    Ramps for Tractor Hauler

    Just for easy reference, most deckover goosenecks that you see a farmer pull is going to be 3-3.5' tall, will have 5' of dove tail and 5' of flip over ramp, so I'd say 10'+ for you. And I'd be sleeving some square tube to weld to the back corners of your truck to make stands for when you load...
  2. 0

    International 2504 compression test in PSI

    I agree with Steve...static compression (compression ratio) does not necessarily translate to cranking compression (PSI). Other variables such as cam profile come in to play. For the sake of completion, your cranking compression should also be done with throttle wide open, fuel supply turned...
  3. 0

    Farmall 350 carburetor help

    Got a little time to mess with this yesterday. Returned original float/needle/seat as recommended, checked height and it was dead on spec, installed on tractor and checked float level externally as before, 1/16 difference from having the new float/needle/seat installed (now 7/16 down instead of...
  4. 0

    Farmall 350 carburetor help

    Thanks for the reply Jim. Initially I was running though the cleaner, with fresh oil, but more recent testing since the second go-thru on the carb has been drawing air straight in to the throat of the carb, partially hoping it would lean it out a bit for diagnostics, partially so I could make...
  5. 0

    Farmall 350 carburetor help

    Understood. Thank you for the reply
  6. 0

    Farmall 350 carburetor help

    Sorry for the terminology mix up Pete, I was indeed referencing the nozzle. Regarding the idle jet, I ran the replacement in the first attempt (marked 72) and put the original back in on the 2nd try (not marked)...same result with both. I understand what you're saying about the kits, but where...
  7. 0

    Farmall 350 carburetor help

    That's the same image I was operating off of to check my fuel height, currently measuring 3/8. ...small brass tube projecting off the carb top--are you referring to the idle jet? If so, this was screwed out and replaced with a new idle jet.
  8. 0

    Farmall 350 carburetor help

    I appreciate the quotes around fixed...one step forward, 10 steps back! I did save the old float/needle/seat so that is an option that I don't mind trying. And the float seemed to be dry so I don't mind putting it back in. Are you hinting at the weight of the new float being off enough to...
  9. 0

    Farmall 350 carburetor help

    I'll try to keep this as short as possible, but in short I'm dealing with a PIG RICH condition after a carb rebuild. Recently purchased '57 350, ran pretty well when I dragged it home. The stand pipe off the manifold had been goober brazed at some point and broke loose when I pulled the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top